High Quality Machinery ,Professional Service, Being The Core Supplier In Paper /Plastic Packing Industrial

Home > News > Content
Punching And Die Cutting MachineApplication Areas
- Aug 22, 2017 -

1. working principle

The working principle of the die-cutting machine is to use the die cutter, steel knife, metal mold, steel wire (or steel plate engraved stencil), through the imprint plate to exert a certain pressure, the printed matter or cardboard rolled into a certain shape. If the entire printed matter pressed into a single graphic product called die-cutting; if the use of steel wire in the printed material on the traces of the traces of leaving or bending marks called indentation; if the use of yin and yang two templates, Heated to a certain temperature, printed on the surface of the printed material with a three-dimensional effect of the pattern or font called bronzing; if a base material on another substrate called the paste; excluding the rest of the original part of the product For the waste; the above can be collectively referred to as die-cutting technology.

2. Work area

Die-cutting machine application areas:

1, stickers products: a variety of electronic: electrical special pads, silicone stickers, Velcro, conductive plastic, strong double-sided adhesive, 3M, Sony special stickers, backlit screen and other electronics industry, IT industry membrane switch, The use of stickers in the industry.

2, dustproof material: cotton, camera cotton, high density sponge, filter cotton, air filter, non-woven fabrics.

3, shock products: back to the pads, rubber, transparent Ottomans, PORON pad, 3M, flame retardant EVA, high foam.

4, insulation material I: fire fast Pakistan paper, aluminum foil, copper foil, PVC, PET, kraft paper, sponge jacket, pearl sheathed.

5, EMI shielding materials: copper foil, aluminum foil, conductive cloth, absorbing material.

6, heat insulation materials: silicone film, transparent mica film, fiber cloth, insulation cotton (cloth).

7, paper packaging materials: corrugated paper, wrapping paper and cardboard.

3. Work procedures

Die-cutting machine stamping products Note:

1, before or after the use of a working period of time, the operation of the machine with lubricating oil (please add 0 # special butter);

2, the use of the process do not hand or other parts of the body into the die-cutting area, please use infrared protection device;

3, please install the debugger in the case of power cut off;

4, the machine stamping products maximum stamping load is not allowed to exceed the nominal pressure of the machine, long-term load work, reduce machine life, the body damaged;

5, work or debugging should follow the progress, not card board, such as card board, please immediately stop, troubleshooting and then use.